Installation - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

Start-up
Please observe the hazard information in section
„2 Hazard information" on page 42.
Permitted cable cross sections for the cable bushings of
the floor heating actuator are (see figure 2):
Cable bushings
1 (K)
2 (L)
3 (M)
4 (N)
Permitted cable cross sections for connecting to the
connecting terminals (H) of the floor heating actuator:
6.2

Installation

You can connect the floor heating actuator to a
230 V socket using the supplied mains cable and
thus provide it with power, or you can use the
connection terminal (H) to connect 24 V
(SELV).
To install the floor heating actuator, please proceed as
follows:
50
Rigid cable: 0.12 – 0.50 mm
Cable cross section [mm2]
> 8.0
> 5.5
> 3.6
> 4.4
2
DC