Mounting; Screw Mounting - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

Mounting

tions provided by the system in combination with other
components are described in the Homematic IP User
Guide. All current technical documents and updates are
provided at www.eQ-3.com.
5 Mounting
You can flexibly mount the floor heating actuator to a
wall using the supplied screws or to a DIN rail.
5.1

Screw mounting

For mounting the floor heating actuator using screws,
please proceed as follows:
• Please select a suitable mounting location close
to your heating manifold.
Make sure that no electricity or similar lines run in
the wall at this location!
• Use a pen to mark the positions of the two bore
holes with a distance of 120 mm on the wall (see
figure 3).
• Use a suitable bit to drill the 6 mm holes as il-
lustrated.
• Use the supplied screws and plugs to fasten the
floor heating actuator (see figure 3).
48