Adding A New Floor Heating Actuator - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

Start-up
figure 7).
• Press and hold down the system button (A) for 4
seconds until the LED (A) quickly starts flashing
orange (see figure 6). Pairing mode remains acti-
vated for 3 minutes.
• Press and hold down the system button of the
Multi IO Box for at least 4 seconds to activate the
pairing mode. The device LED flashes orange.
The device LED (A) lights up green to indicate that pairing
has been successful. If pairing failed, the device LED (A)
lights up red. Please try again.
6.4.3

Adding a new floor heating actuator

To add a new floor heating actuator to the system or to
the existing devices, please proceed as follows:
• First pair the new floor heating actuator with an
existing one. Activate the pairing mode of the ex-
isting floor heating actuator. Therefore, press and
hold down the system button (A) for at least 4
seconds (see figure 6).
• Activate the pairing mode of the new floor heating
actuator. Press and hold down the system button
(A) for at least 4 seconds.
The device LED (A) lights up green to indicate that
pairing has been successful. If pairing failed, the
device LED (A) lights up red. Please try again.
54