10.3.2 Error Codes In The Display - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

1x orange and 1
x green lighting

10.3.2 Error codes in the display

Flashing code
Open-end wrench
flashes at intervals
of 0.5 s
Exclamation mark
flashes at intervals
of 0.5 s
Test display
Meaning
Adaptation run
at the heating
zone could not
be carried out
The heating
zone is in
emergency
mode
Troubleshooting
Once the test dis-
play has stopped,
you can continue.
Solution
Check that the
actuator is cor-
rectly mounted
on the valve
and that the
connector is
plugged into
the right socket.
Perform a com-
munication test,
reposition the
wall thermostat
if necessary,
change wall
thermostat bat-
teries or replace
defective wall
thermostat.
67