Troubleshooting; Error Codes And Flashing Sequences; Command Not Confirmed - Homematic IP HmIP-DRSI4 Installation And Operating Manual

7

Troubleshooting

7.1

Error codes and flashing sequences

Flashing code /
LC display
Short orange
flashing (every
10 s)
6x long red
flashing
1x orange and
1x green
lighting
E10
7.2

Command not confirmed

If at least one receiver does not confirm a command, the
device LED (A) lights up red at the end of the failed trans-
mission process. The failed transmission may be caused
by radio interference (see "10 General information about
Meaning
Teach-in
mode active
Device
defective
Test display
Temperature
too high
Troubleshooting
Solution
Enter the last four
numbers of the
device serial number
to confirm (see "5.3
Teaching-in" on
page 49).
Have a look at
your app for error
message or contact
your retailer.
Once the test
display has stopped,
you can continue.
Reduce the con-
nected load and
let the device cool
down.
53