Fujitsu Waterstage WOYG160LJL Installation Manual page 47

Ref. Functions
1 Selecting the DHW operation
2 Digital display
"ESC" output
3
Navigation and setting
4
Selecting the heating operation
5
6 Displaying information
Validation "OK"
7
Selection of the refresh mode
8
Reset
9
(Press and relief)
Setting button
10
Presence button
11
Waterstage / Installation / 2011 - EN
- Definition of the functions
- Start: Production of DHW in function of the timer programme.
- Stop: Production of the DHW stopped with antifreeze function of the
Marche
domestic water active.
- Manual start button: Press the DHW button for 3 s (switches from
"reduced" to "comfort" until the DHW timer programme is switched again).
Arrêt
- Check the operation, read the current temperature of the heating
operation, or a possible fault.
- View the settings.
- Exit the menu.
- Setting the comfort temperature value.
- Menu selection
- Setting the parameters.
Auto
- Service heating according to the heating programme
(automatic summer/winter switching).
- Permanent comfort temperature.
- Permanent reduced temperature.
- "Stand-by" operation with antifreeze protection (provided that the
electrical power supply of the heat pump is not interrupted).
- Miscellaneous information (see
- Reading the error codes (see
- Information on maintenance, special operation.
- Enter the selected menu.
- Validate the parameter settings.
- Validate the comfort temperature value setting.
- Service cooling according to the heating programme
(automatic summer/winter switching).
- Reset the parameters and cancel the error messages.
Do not use during normal operation
- Setting the comfort temperature value.
- Comfort / reduced switching.
"Information display", page
" Fault Diagnosis", page
66).
74).
- 47 -