Electrical connections
Before any maintenance operation,
ensure that the general power supply is switched off.
Electrical installation must be performed in accordance with current regulations.
The electrical diagram for the hydraulic unit is shown on
Cable 2 x 0.75 mm²
Interconnection between
outdoor unit and hydraulic unit
Phase, Neutral, Earth, Communication bus)
Cable 4 G 1.5 mm²
fig. 29 - Overall layout of electrical connections for a simple installation (1 heating circuit)
- 34 -
Outside sensor
fig. 43, page
72.
Wireless remote control (option)
Wireless room thermostat (option)
OK
ESC
Electrical backup power supply
(see table below)
General power supply
(see table below)
1
Remote control (option)
Cable 2 x 0.5 mm²
Room thermostat (option)
Cable 2 x 0.5 mm²
Electrical
Board
Waterstage / Installation / 2011 - EN
2
U0629273-A
or
or
or