3.
Place the LockIt Lacing Bracket on the screw and against the
HDMI connector (see figure 13,
tighten the screw to secure the bracket.
ATTENTION:
4.
Loosely place the included tie wrap around the HDMI
connector and the LockIt Lacing Bracket (
5.
While holding the connector securely against the lacing
bracket, use pliers or a similar tool to tighten the tie wrap (
and then remove any excess length.
TP connectors
All RJ-45 ports, whether DTP ports, the Expansion port, and the
LAN (Ethernet) ports on the switcher or IPCP control processor use
twisted pair cables (see figure 14).
Pins:
12345678
Pin
1
2
3
4
5
6
7
8
Insert Twisted
Pair Wires
RJ-45
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
Connector
reversed) is a "crossover" cable.
Figure 14.
Patch (straight) cable —
•
•
•
•
12
DTP CrossPoint 4K Series • Installation
•
Do not overtighten the HDMI connector mounting screw.
The shield it fastens to is very thin and can easily be
stripped.
•
Ne serrez pas trop la vis de montage du connecteur
HDMI. Le blindage auquel elle est attachée est très fin et
peut facilement être dénudé
Crossover Cable
End 1
End 2
Wire color
Wire color
White-green
White-orange
Green
Orange
White-orange
White-green
Blue
Blue
White-blue
White-blue
Orange
Green
White-brown
White-brown
Brown
Brown
T568A
T568B
RJ-45 Connector and Pinout Tables
DTP input and output ports — Shielded twisted pair
(STP) (preferred) or unshielded TP for connection to
Extron DTP transmitters and receivers, XTP matrix
switchers, or HDBaseT-enabled devices.
Expansion port — STP for connection between the
matrix switcher and a DMP 128. A shielded 1-foot cable is
included with the DMP 128.
AV LAN and LAN ports — Unshielded twisted pair (UTP)
or STP for connection of the LAN port to an Ethernet LAN.
3
, on page 11), and then
4
).
Straight-through Cable
End 1
Pin
Wire color
1
White-orange
White-orange
2
Orange
Orange
3
White-green
White-green
4
Blue
Blue
5
White-blue
White-blue
6
Green
Green
7
White-brown
White-brown
8
Brown
Brown
T568B
A cable that is wired the same at both ends is
called a "straight-through" cable, because
no pin/pair assignments are swapped.
5
),
End 2
Wire color
T568B