Sound Sensitivity; Dmx Address; Slave Mode; Ir Remote Control Mode - SHOWTEC Galactic RGB-600 Value Line Manual

Galactic RGB-600 Value line

3. Sound sensitivity

In this menu you can set the sensitivity of the Sound-controlled programs.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between
sensitivity.
03) Choose the desired sensitivity and press the ENTER button to confirm.
04) The Galactic will immediately adjust the sensitivity of the desired Sound-controlled program.

4. DMX address

In this menu you can set the DMX address.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose the desired DMX address, the adjustment range is between
03) Set the desired DMX address and press the ENTER button to confirm.

5. Slave mode

In this menu you can set the fixture as a Slave device.
01) Press the FUNC button until the display shows
02) Press the ENTER button to confirm.
03) If the device has not been set to slave, it is automatically classified as a master device. If the device
has been set to slave, it will react the same as its master device.

6. IR remote control mode

In this menu you can activate the IR-remote mode.
01) Press the FUNC button until the display shows
02) Press the ENTER button to confirm.
03) In any standalone mode (excepted REM and SLA), press ON/OFF for 2 seconds to activate the
remote function.
04) Please see page 20 about the functions of your remote control.

7. Pattern mode

In this menu you can set the mirror and reverse options.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between 4 options:
Normal mirror mode
x-axis reverse
y-axis reverse
x-axis and y-axis reverse
03) Press the ENTER button to confirm.
Ordercode: 51325
.
.
, from low sensitivity to high
.
.
.
.
19