Multiple Galactics (Master/Slave Mode) - SHOWTEC Galactic RGB-600 Value Line Manual

Galactic RGB-600 Value line

Multiple Galactics (Master/Slave Mode)

01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the Galactics and other devices.
The pins:
05) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units. You can
use the same functions on the master device as described on pages 18 (Auto Program, Sound-
controlled). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
Multiple Galactics Master/Slave Set Up
Ordercode: 51325
01) Earth
02) Signal (-)
03) Signal (+)
13
Fig. 03