Auto Run Programs; Sound-Controlled Mode; Sound Sensitivity; Dmx Address - SHOWTEC Galactic RGB300 Manual

Galactic RGB300

1. Auto Run Programs

With this menu you can start several Auto run programs.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between 7 types of built-in programs
03) Choose the desired built-in program and press the ENTER button to confirm.
04) The Galactic will immediately start the desired Auto run program.
The software will now run a pre-programmed laser show.
The speed and the characteristics of the show cannot be modified in this mode.

2. Sound-controlled Mode

With this menu you can choose several Sound-controlled programs.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons until the display shows
03) Press the UP/DOWN buttons to choose between 7 types of built-in programs
04) Choose the desired built-in program and press the ENTER button to confirm.
05) The Galactic will immediately start the desired Sound-controlled program.
The software will now run a pre-programmed laser show.
The speed and the characteristics of the show cannot be modified in this mode.

3. Sound sensitivity

With this menu you can set the sensitivity from the Sound-controlled programs.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between
sensitivity.
03) Choose the desired sensitivity and press the ENTER button to confirm.
04) The Galactic will immediately adjust the sensitivity from the desired Sound-controlled program.

4. DMX address

With this menu you can set the DMX address.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose the desired DMX address, the adjustment range is between
.
03) Set the desired DMX address and press the ENTER button to confirm.

5. Slave mode

With this menu you can set the device as a Slave.
01) Press the FUNC button until the display shows
02) Press the ENTER button to confirm.
03) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master movement. If the device has been set to slave, it will react the same as
its master device.
Ordercode: 51345
.
.
.
.
, from low sensitivity to high
.
.
17
.
.