Main Menu Options; Auto/Sound Programs; Auto/Sound Patterns - SHOWTEC Galactic RGB-600 Value Line Manual

Galactic RGB-600 Value line

Main Menu Options

Auto/Sound Programs

Auto/Sound Patterns

Sound sensitivity
DMX Address
Slave mode
IR remote control mode
Pattern mode
You can only change a certain setting when the display is blinking.
If you cannot change a certain value, please press the FUNC button once and then change the value.
1. Auto/Sound Programs
In this menu you can start several Auto or Sound-controlled programs.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between 4 options:
Auto program fast
Auto program slow
Sound-controlled program slow
Sound-controlled program fast
03) Choose the desired built-in program and press the ENTER button to confirm.
04) The Galactic will immediately start the desired Auto or Sound-controlled program.
The software will now run a pre-programmed laser show.
The speed and the characteristics of the show cannot be modified in this mode.
2. Auto/Sound Patterns
In this menu you can start the Auto or Sound-controlled patterns.
01) Press the FUNC button until the display shows
02) Press the UP/DOWN buttons to choose between 2 options:
Auto program patterns
Sound-controlled patterns
03) Choose the desired built-in program and press the ENTER button to confirm.
04) The Galactic will immediately start the desired Auto or Sound-controlled patterns.
The software will now run a pre-programmed laser show.
The speed and the characteristics of the show cannot be modified in this mode.
Ordercode: 51325
.
.
18