Laser Safety; Examining The Installation Site; Temperature - HP Aruba 6400 Series Installation And Getting Started Manual

ground, wear the strap snug against the skin.
1
1 Remove the bezel and clip the alligator clamp onto the tab used to mount the bezel.
2 Clip the alligator clamp onto the grounding lug.
If you do not have any of the suggested equipment for proper grounding, have an Aruba authorized reseller
install the part.
For more information on static electricity or assistance with product installation, contact an Aruba
authorized reseller.

Laser safety

WARNING: Do not stare into any fiber port or view directly with non-attenuating optical
instruments when the switch has power. The laser light emitted from the fiber port may injure
your eyes.
The Aruba 6400 switches are Class 1 laser products.

Examining the installation site

The switch must be used indoors. To help ensure correct operation and a long service life for your switch,
the installation site must meet the requirements in this section.

Temperature

CAUTION: If condensation appears on the chassis when you move it to a high-temperature
environment, dry the chassis before powering it on to avoid short circuits.
To ensure correct switch operation, make sure the room temperature meets the following requirements.
NOTE: Above 1524m (5000ft), reduce maximum operating temperature by 1°C (1.8°F) per 305m
(1000ft) altitude gain.
14
2
Aruba 6400 Switch Series Installation and Getting Started
Guide