Removing The Fan Tray - HP Aruba 6400 Series Installation And Getting Started Manual

CAUTION: Handle your Aruba 6400 switch fan trays with care. Rough or careless handling can
damage these components and result in unplanned down time.
Figure 29: Aruba 6405 rear panel with two fan trays
1 Installed AC inlet accessories PSU slots 2 - 4
2 Open AC inlet accessory slot for PSU slot 1
3 Rear panel LEDs
4 Fan tray installed in fan tray slot 1 of the Aruba 6405 Switch
5 Fan tray installed in fan tray slot 2 of the Aruba 6405 Switch
6 Grounding lug
Prerequisites
• For an Aruba 6405 Switch, ensure that there will be one fully functional fan tray operating after you
remove the fan tray you are replacing.
• For an Aruba 6410 Switch, ensure that there will be three fully functional fan trays operating after you
remove the fan tray you are replacing.
• Unpack the replacement fan tray and place it on an antistatic surface.
• Put on an ESD wrist strap and properly ground it on the switch. See Protect the switch and
components from damage caused by ESD (Electrostatic discharge).

Removing the fan tray

88
1
6
2
3
Power Supplies
4 3 2 1
UID
1
2
4
5
Aruba 6400 Switch Series Installation and Getting Started
Guide