Device Preparation - Dog trace d–mute User Manual

Device preparation

Battery insertion and replacement
1. Screw out 4 screws from the battery cover using a cross-head screwdriver and remove
the lid.
2. Insert a lithium battery CR2 3V into the battery compartment with a correct polarity
(according to the polarity indicated with the "+" symbol in the battery compartment).
Wrong polarity may damage the unit.When is the battery inserted correctly, the device
should make a sound.
3. Make sure that the rubber seal is clean and correctly seated in its groove.
4. Put the battery cover back and screw in the 4 screws adequately.
Checking the battery status
● When the battery is inserted the device is set into the standby or active mode.
● If the product begins to make a continuous beep tone, the battery is low. Insert a new
lithium battery CR2 3V in the device.
● If you are not using the device for longer period, take the battery out.
Choice of the contact points
The stimulation is transferred on your dog's skin through the steel contact points of the
electronic device. Each set contains 2 types of contact points with the flat base, which
enable the vocal cords vibration transmission. Sufficient length of the contact points has
to have a contact with the dog's skin, enabling the device to operate correctly. If you have
a short-haired dog use the 10 mm contact points, if you have a long-haired dog replace
them with the longer 17 mm contact points supplied in the kit. Screw the contact points
8