Dog trace d–mute User Manual page 12

Number of
Mode*
indication beeps
1
2
3
4
5**
6***
* The choosen mode can be found out by number of beeps, when you put the magnet
shortly to the target on the device (see pic. on page 11). To change the mode put the
magnet to the target for longer period and wait until you hear desired number of beeps
(1 - 6).
* * The 5
th mode with five increasing levels essentially replicates the functionality of
previous modes. After activation follows an acoustic beep tone and low stimulation
impulse in the event that the dog is not deterred and still barks, it is followed by another
and higher stimulation impulse, so the process is repeated until the highest pacing
impulse. By the 5 th
reasons impulses stop for 15 seconds and then it re-enters standby mode. Upon further
activation is the process repeated again from the lowest impulse, when the dog stops
barking, collar goes into standby mode.
Attention: 4 th and 5
4 (high).
12
Table of correction modes
Collar function
1 beep tone correction only
2 beep tone + low level stimulation impulse
3 beep tone + medium level stimulation impulse
4 beep tone + high level stimulation impulse
5 beep tone + stimulation impulse in 5 increasing levels
6 operation test
impulse this mode ends, even if the dog is still barking, for security
th stimulation impulse at the 5 th mode is stronger than in mode