Dog trace d–mute User Manual page 13

* * * Operation test is a mode, which is used to verify proper operation of sound and
stimulation impulse. Connect each wire of the test discharge lamp to the one contact point
(loosen the contact points, put the wires under the lamp outlets and tighten again). When
selecting the mode, no. 6 (operation test) you should hear the acoustic signal + electro-
nic impulse comes ON (test lamp lights up), then the software switches itself to a mode 1
(acoustic beep tone). If you don´t hear a long acoustic signal or if it does not light up send
to the service.
Setting reaction to vibration (vibration detection sensitivity) with a trimmer
The reaction to the vibration means that the device is activated by vibrations of the dogs
vocal cords. If your device only reacts to a significant or contrariwise on bland vibration of
vocal cords, which are scanned by the contact points, you can adjust the sensitivity of the
collar so it starts working only at the right moment. This (sensitivity) setting is important
for the proper function of the device.
Sensitivity setting
d–mute small d–mute
Trimmer for fine adjustment setting
13