Troubleshooting - Husqvarna 535RX Operator's Manual

• Make sure that the product and blade has sufficient
support when you sharpen it.
• Use a 5.5 mm round file with a file holder.
• Hold the file at an angle of 15°.
• Sharpen one tooth of the saw blade to the right and
the next tooth to the left, see the illustration.
The engine does not start
Check
Stop switch.
Starter pawls.
26
15˚

Troubleshooting

Possible cause
The stop switch is in the stop posi-
tion.
The starter pawls cannot move free-
ly.
Note: Sharpen the edges of the teeth with a flat file if
the blade is heavily worn. Continue to sharpen with a
round file.
• Sharpen all edges equally to keep the blade
balanced.
• Adjust the blade set to 1 mm with the recommended
setting tool. Refer to the instructions that come with
the blade.
WARNING: Always discard a blade that is
damaged. Do not try to make a bent or
twisted blade straight and use it again.
Procedure
Let an approved service agent re-
place the stop switch.
Remove the starter cover and clean
around the starter pawls. See
uct overview on page 2 .
Let an approved service agent help
you.
Prod-
1069 - 005 -