Husqvarna 535RX Operator's Manual page 6

ANSI Z87.1 standard in the USAs or EN 166 in EU
countries.
• Use gloves when necessary, for example when you
attach, examine or clean the cutting equipment.
• Use protective boots with steel toes and non-slip
soles.
• Use clothing made of a strong fabric. Always use
heavy, long pants and long sleeves. Do not use
loose clothing that can catch on twigs and branches.
Do not wear jewelry, short pants, sandals or go with
bare feet. Put your hair up safely above shoulder
level.
• Keep first aid equipment close at hand.
Safety devices on the product
For information about where to find the safety devices,
Safety instructions for assembly on page 4 .
see
WARNING: Read the warning instructions
that follow before you use the product.
• Do not use a product with defective safety devices.
Do a check of and do maintenance on the safety
devices regularly. If the safety devices are defective,
speak to your Husqvarna service agent.
6
• Do not make changes to safety devices. Do not use
the product if protective covers, safety switches or
other protective devices are not attached or are
defective.
• For all service and repair work on the product,
especially for the safety devices, special training is
necessary. If the safety devices fail the checks given
in this operator's manual, you must let a service
agent help you. We guarantee that professional
repairs and service is available. If your dealer is not
a service agent, speak to them for information about
the nearest service agent.
• Do not use a cutting attachment without an approved
and correctly attached cutting attachment guard. See
To assemble the cutting equipment on page 11 .
Cutting attachment
WARNING: The cutting attachment must not
rotate when you do work on it. Make sure
that the engine has stopped. Remove the
spark plug cap before you do work on the
cutting attachment.
WARNING: Make sure that the cutting
attachment is not damaged. A damaged
cutting attachment can cause accidents.
Replace a damaged cutting attachment.
WARNING: Use the correct cutting
attachment. Only use the cutting attachment
with the guards we recommend, refer to
Accessories on page 29 .
To do a check of the throttle trigger lockout
1. Make sure that the throttle trigger lockout (A) and
throttle trigger (B) move freely and that the return
spring works correctly.
B
A
1069 - 005 -