Operation - Husqvarna 535RX Operator's Manual

2. Push the 2 parts of the breastplate together.
3. Tighten the hip strap tightly. Make sure that the hip
strap aligns with the hip.
4. Tighten the chest strap below your left arm tightly.
The chest strap must be tight against your body.
5. Adjust the shoulder strap until the weight is equal on
your shoulders.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
14
6. Adjust the height of the suspension point. For
forestry clearing, the correct height of the
suspension is approximately 10 cm below your hip.
Correct balance of the product on page 16 .
Refer to
Quick release function of the harness
WARNING: Do not use the harness if the
quick release function is defective. Make
sure that the quick release function operates
correctly when you adjust the product.
WARNING: If the product is not safely
attached to the harness, you can not control
the product and that can result in injury to
you or others.
The quick release function is at the front of the harness.
The harness straps must always stay at the correct
position.
In an emergency, the quick release function helps you to
remove the product safely.

Operation

Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
1069 - 005 -