Husqvarna 535RX Operator's Manual page 7

2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING: If the blades move when the
throttle trigger is in the idle position, then
the carburetor idle speed must be
adjusted. Refer to
speed on page 25 .
1069 - 005 -
To adjust the idle
Stop switch
Start the engine. Make sure that the engine stops when
you move the stop switch to the stop position.
To do a check of the cutting attachment guard
WARNING: An incorrect or defective cutting
attachment guard can cause serious injury.
Safety instructions for operation on
Refer to
page 4 .
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
defective cutting attachment guard is
installed, this can cause serious injury. Refer
Technical data on page 28 .
to
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment.
1. Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
damaged.
7