Husqvarna 535RX Operator's Manual page 17

For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.
To prepare the product for start
1. Press the air purge again and again until the fuel
starts to fill the bulb.
Note: It is not necessary to fully fill the bulb.
2. Move the choke control up into choke position.
WARNING: The cutting attachment will
start to rotate immediately when you
start the engine with the choke.
To start the product
WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
1069 - 005 -
Safety on page 4 ).
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.
To start with a throttle handle with a
start throttle lock
1. Push the throttle lockout and the throttle trigger to
set the throttle to the start position. Then push the
start throttle button (A).
2. Release the throttle lockout and the throttle trigger,
followed by the start throttle button. The throttle
function is now activated.
3. To return the engine to idle speed, push the throttle
lockout and throttle trigger again.
To stop the product
• Move the stop switch to the stop position to stop the
engine.
A
17