Troubleshooting - Husqvarna 325iLK Operator's Manual

Hide thumbs Also See for 325iLK:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Maintenance
Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the power button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons on the battery works and locks the
battery in the product.
Make sure that the battery is not damaged.
Make sure that the battery is charged.
Make sure that the battery charger is not damaged and operates correctly.
Examine all cables, couplings and connections. Make sure they are not dam-
aged and free from dirt.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
Keypad
LED display
Green activate LED flashing
Red error LED flashing
1318 - 009 - 27.09.2023

Troubleshooting

Possible faults
Low battery voltage.
Overload.
Temperature deviation.
The power trigger and the acti-
vate button are pressed at the
same time.
Two piece-shaft
Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
(Fig. 30)
Possible action
Charge the battery.
The cutting attachment is jammed. deacti-
vate the product. Remove the battery. Clean
the cutting attachment from unwanted mate-
rials.
Let the product cool down.
Release the power trigger and the product is
active.
Daily
Weekly
Monthly
X
X
X
X
X
X
X
X
X
X
X
X
13

Advertisement

Table of Contents
loading

Table of Contents