Husqvarna 535RX Operator's Manual page 11

To assemble the handlebar
1. Put the handlebar into the bracket.
2. Make sure that the holes for the screws align.
3. Attach the 4 screws but do not tighten fully.
4. Adjust the handlebar to put the product in a good
operation position.
5. Tighten the 4 screws fully.
To assemble the handlebar
1. Put the handlebar into the bracket.
2. Make sure that the holes for the knob align.
3. Attach the knob but do not tighten fully.
1069 - 005 -
4. Adjust the handlebar to put the product in a good
operation position.
5. Tighten the knob fully.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 29 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To attach the trimmer guard or combination
guard for trimmer head and plastic blades
1. Hang the trimmer guard/combination guard (A) onto
the two hooks on the plate holder (M).
2. Bend the guard around the shaft and attach it with
the bolt (L) on the opposite side of the shaft.
3. Put the locking pin (C) in the groove on the bolt head
and tighten the bolt fully.
M
A
To attach a trimmer head or plastic blade
1. Put the drive disc (B) on the output shaft.
2. Align the metal cup (P) with the center of the blade
guide on the drive disc.
Accessories on
L
C
11