Table of Contents
Advertisement
The bar angle is adjustable manually using the brackets located on each side of the unit. Simply
loosen the tilt adjustment knobs attached to each mounting bracket and adjust the bracket accord-
ingly. After making your desired set up, securely tighten the tilt adjustment knobs. The image below
illustrates a 90-degree configuration.
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A DIELECTRIC
GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT WATER CORROSION
AND/OR ELECTRICAL SHORT CIRCUIT.
TO MAINTAIN IP65 RATING INTEGRITY AND PREVENT WATER FROM ENTERING THE
FIXTURE, ALL CONNECTION RUBBER CAPS MUST BE SEALED WHEN NOT IN USE.
MANUAL TILT ADJUSTMENT
CONNECTIONS
12
Advertisement
Table of Contents
Need help?
Do you have a question about the 15 HEX BAR IP and is the answer not in the manual?
Questions and answers