BOMBARDIER SeaDoo Speedster 200 Operator's Manual page 82

Spray Bombardier Lube™ lubricant or
equivalent, into spark plug holes.
Apply anti-seize lubricant on spark plug
threads then reinstall them.
Crank each engine a few turns to dis-
tribute the oil on cylinder wall.
NOTE: Prior to inserting the ignition coil
to its location, apply some Molykote 111
grease (P/N 413 707 000) around the
seal area that touches the spark plug
hole. After installation, ensure the seal
seats properly with the engine top sur-
face.
Reinstall ignition coils. Reconnect igni-
tion coil connectors.
To reinstall fuel rail cover, remove dip-
stick, push fuel rail cover downward
until it snaps.
Reinstall dipstick.
NOTE: It is recommended to fog the
engine valves with Bombardier Lube™
lubricant. Contact your authorized Sea-
Doo dealer.
Battery
Contact your authorized Sea-Doo dealer.
Engine Cooling System
Antifreeze should be replaced for the
storage period to prevent antifreeze
deterioration.
A density test and/or antifreeze replace-
ment should be performed by an autho-
rized Sea-Doo dealer.
CAUTION: Improper antifreeze mix-
ture might allow freezing of the liq-
uid in the cooling system if vehicle is
stored in area where freezing point is
reached. This would seriously dam-
age the engine. Failure to replace the
antifreeze for storage may allow its
degradation that could result in poor
cooling when engine will be used.
WARNING
In order to avoid potential burns, do
not remove the radiator cap or loos-
en the engine drain plug if the en-
gine(s) is/are still hot.
Boat Cleaning/Repair
Wash the body and the trailer with soap
and water solution (only use mild deter-
gent). Rinse thoroughly with fresh wa-
ter. Remove any marine organisms
from the hull.
CAUTION: Never clean apparent fi-
berglass and plastic parts with
strong detergent, degreasing agent,
paint thinner, acetone, etc.
Stains may be removed from seats and
fiberglass with Knight's Spray-Nine
the equivalent.
If repairs are needed to the body or to
the hull contact your dealer. For paint
touch up to mechanical parts use Bom-
bardier spray paint. For minor gelcoat
repairs, a Bombardier repair kit is avail-
able. Replace damaged labels/decals.
Clean the bilge with hot water and de-
tergent or with bilge cleaner. Rinse
thoroughly. Unscrew drain plug and lift
front end of sport boat to completely
drain bilge.
Finalizing Storage Preparation
Apply a non-abrasive wax to body.
The engine storage cover should be
left partially opened during storage
(detach the gas shocks from the cover
to prevent full opening). Remove stor-
age tray. Place it on deck. This will
avoid engine compartment condensa-
tion and possible corrosion.
If the sport boat is to be stored out-
side, cover it with a vented opaque tar-
paulin to prevent UV (ultraviolet) rays
and grime from affecting the plastic
components, sport boat finish, as well
as preventing dust accumulation.
1. Knight's Spray Nine is a registered trademark of
Knight Oil Corporation
1
or
83