Bilge Air Blower Switch; Bilge Pump Switch; Navigation Light Switch - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

Table of Contents

Advertisement

6) Bilge Air Blower Switch

F10A03Y
A 2-position OFF/blower switch. When
turned on, the blower ventilates the en-
gine compartment.
WARNING
Gasoline vapors can explode, re-
sulting in injury or death. Before
starting engine, operate blower
5
for
minutes and check engine
compartment bilge for gasoline
vapors.
Using the bilge blower for a prolonged
time when the engines are not running
will discharge the battery.
Blower should be turned off during
boat operation.

7) Bilge Pump Switch

F10A02Y
1. Bilge
A 2-position OFF/bilge switch.
Turn to bilge position when a manual
operation is required (after cleaning,
storage, etc.).
Turn it to OFF when finished.
CAUTION: Do not operate for pro-
longed time if the bilge is dry, bat-
tery drainage will occur.
The bilge pump may be operated with-
out the safety lanyard on its switch.
CAUTION: Ensure to always turn
pump OFF when bilge is dry or be-
fore operating the engine above
idle. Bilge pump will then switch to
automatic mode.
Automatic Bilge Pump
An automatic bilge pump will evacuate
water from the bilge. A water sensor
detects the water which activates the
pump. After the water is pumped out,
the pump shuts-off automatically. This
automatic mode is working at all
times: with/without safety lanyard on
DESS post and with/without engines
running.
CAUTION: Bear in mind that when
the main battery cut-off switch is
turned OFF while craft is moored,
the bilge pump will not start if water
comes up in the bilge.

8) Navigation Light Switch

WARNING
Navigation lights should always
be used between sunset and sun-
rise. Ensure the stern light is in-
stalled. See Removable Stern Light
in this section for location and in-
stallation.
F10A01Y
41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents