Towing The Sport Boat In Water; Low-Charge Battery Condition - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

NOTE: Prior to inserting the ignition coil to
its location, apply some Molykote 111
grease (P/N 413 707 000) around the seal
area that touches the spark plug hole. Af-
ter installation, ensure the seal seats prop-
erly with the engine top surface.
Start engine(s) as explained above. If
engine(s) continue to flood, see an au-
thorized Sea-Doo dealer.
CAUTION: Never run an engine with-
out supplying water to the exhaust
cooling system when sport boat is
out of water.
Towing the Sport Boat in
Water
Special precautions should be taken
when towing a Sea-Doo sport boat in
water.
Maximum recommended towing speed
is 24 km/h (15 MPH).
When towing your sport boat in water,
pinch the water supply hose on each
engine from the impeller housing to
the exhaust manifold with a large hose
pincher (P/N 529 032 500).
F01B23Y
This will prevent the exhaust cooling
systems from filling which may lead to
water being injected into and filling the
engines. Without the engines running
there isn't any exhaust pressure to car-
ry the water out the exhaust outlet.
CAUTION: Failure to do this may re-
sult in damage to the engines. If you
must tow a stranded sport boat in
water and do not have a hose pinch-
ers, be sure to stay well below the
maximum towing speed of 24 km/h
(15 MPH).
Snugly install the hose pinchers on the
water supply hoses as shown for each
engine.
F09D0TY
TYPICAL
1. Hose pincher
CAUTION: When finished towing
the sport boat, hose pinchers must
be removed before operation. Fail-
ure to do so will result in damage to
the engines.
Low-Charge Battery
Condition
WARNING
See your authorized Sea-Doo deal-
er to have it charged or replaced.
Do not charge or boost the battery
while installed on the craft. Electro-
lyte is poisonous and dangerous.
1
71