Hull; Jet Pump Water Intakes; Bilge; Battery - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

Hull

Inspect hull for cracks or damage.

Jet Pump Water Intakes

Remove weeds, shells, debris or any-
thing else that could restrict the flow
of water and damage the cooling sys-
tems or propulsion units. Clean as nec-
essary. If any obstruction can not be
removed, refer to an authorized dealer
for servicing.
F04J1LY
TYPICAL
1. Inspect this area
Inspect leading edges of the impellers,
if they have nicks or bends, perfor-
mance will be greatly reduced.

Bilge

Should water be present in the bilge,
turn on pump switch to completely emp-
ty the bilge.
WARNING
Make sure drain plug is properly
secured prior launching the craft
in water.

Battery

WARNING
Verify tightness of battery cables
to their posts and condition of re-
taining straps/fasteners. Do not
boost battery while installed.

Fuel Tank/Oil Levels

With the craft horizontal, fill the fuel tank.
Check the oil level in each engine and re-
fill as necessary.
Check fuel tank retaining straps/fasteners.

Engine Compartment

Should any leak or gasoline odor be
present, do not start the engines.
Consult an authorized dealer.
In order to avoid potential burns, do
not remove the radiator cap or loos-
en the engine drain plug if the en-
gine(s) is/are still hot.

Fire Extinguisher

1
Make sure it is full, in good condition
and well secured.

Steering System

Assisted by another person, check steer-
ing operation for free movement. When
the steering is centered, the jet pump
nozzles should be in the straight ahead
position. Ensure the jet pump nozzles
pivot easily while steering is turned.
Check steering and corresponding
steering nozzle operation before
starting engines.

Throttle System

Check throttle levers for free and
smooth operation.
Check throttle levers operation be-
fore starting the engines.
WARNING
WARNING
WARNING
WARNING
59