Pre-Operation Checks - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

PRE-OPERATION CHECKS

WARNING
The pre-operation check is very
important prior to operating the
vehicle. Always check the proper
operation of critical controls, safe-
ty features and mechanical com-
ponents before starting. If not
done as specified here, severe in-
jury or death might occur. Bring all
safety equipment required by lo-
cal laws.
SUMMARY
ITEM
Hull
Jet pump water intakes
Bilge
Battery
Main battery cut-off switch
Navigation lights
Fuel tank/engine oil (P/S)
Engine compartment
Fire extinguisher
Steering
Throttle/shifter system
ICS (Inlet Clearance System)
Bilge blower and bilge pump
Safety lanyard/engine start/stop
buttons
Mandatory safety boating
equipment
Storage compartment covers
Engine Coolant (anti-freeze)
58
Some of the following items may not
have been previously covered in this
guide, however they will be described
in the MAINTENANCE or SPECIAL
PROCEDURES section. Please refer
to these portions to have more de-
tailed information.
Engines should be off and the
safety lanyard must always be re-
moved from its switch prior to ver-
ifying any of the following. Only
start craft once all items have been
checked and operate properly.
OPERATION
Inspect.
Inspect/clean.
Drain. Ensure plug is secured.
Inspect tightness of cables and retaining straps.
Ensure it is in the ON position.
Check operation.
Refill.
Verify fuel/oil system components.
Inspect condition/mounting.
Check operation.
Check operation.
Ensure it is not activated.
Check operation.
Check operation.
Check operation.
Ensure they are closed and latched.
Ensure proper level is in each engine.
WARNING