Shift Lever - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

F09L08Y
TYPICAL — THROTTLE LEVERS
1. Port engine
2. Starboard engine
3. Full throttle
4. Increase speed
5. Decrease speed
6. Idle speed
The port throttle lever controls the
RPM of the port engine and the star-
board lever controls the RPM of the
starboard engine. Although each en-
gine RPM can be controlled individual-
ly, we recommend moving both levers
at the same time.

4) Shift Lever

A 3-position lever:
– forward
– neutral
– reverse.
In order to shift, throttle levers must
be fully pulled back to idle speed.
Shifter must be in neutral position to
allow starting engines.
NOTE: 4 short beeps will signal that
shifter is not in neutral (with the safety
lanyard on the DESS post while press-
ing one of the start/stop button). There-
after, 1 short beep will confirm the neu-
tral position (while shifting).
2
5 6
3 4
1
2
F09L08Z
TYPICAL — SHIFT LEVER
1. Throttle levers must be fully pulled back
(idle speed) to shift
2. Forward
3. Neutral
4. Reverse
CAUTION: Do not force lever, insure
throttle levers are in idle position be-
fore shifting.
NOTE: To ease shifter use, line up the
shifter arrow with the appropriate dot
(Forward/Neutral/Reverse).
F10L0BY
TYPICAL
1. Dots besides shifting position
2. Arrow on shifter
WARNING
Shift lever should only be used
when the engine is idling and craft
is completely stopped.
3
4 1
1 2
39