Bilge Air Blower - BOMBARDIER SeaDoo Speedster 200 Operator's Manual

Fuses for the accessories and the
gauges are mounted in the gauge in-
terface, which is located behind the
dash.
1
F09H16Y
TYPICAL
1. Interface
2. Fuse cover
3. Use these tabs as a fuse puller
Squeeze cover locking tabs and pull
cover out to access fuses.
Use the cover tabs to remove the fuse.
F04H63Y
1. Slide cover tabs each side of fuse then pull
fuse out
3
1
F09H17Y
TYPICAL — INTERFACE
1. Radio
2. 12-Volt jack
3. Blower
4. Navigation lights
2
5. Bilge pump
6. Spare
When finished, ensure to properly place
seal in cover.
Carefully position cover on fuse block
then firmly push until you hear a snap-
ping sound for each locking tab.
Charging System
If the battery is regularly discharged,
check this fuse condition.
Fuses for the charging systems are lo-
cated near the fuse blocks at the start-
er relays in the engine compartment.

Bilge Air Blower

Verify bilge air blower for proper oper-
ation. It is located in starboard ventila-
tion duct beneath rear storage com-
partment cover.
F13L1HZ
TYPICAL
1. Blower
6
5
4
3
2
1
1
79