Illustration 5.18: Usb Connection - Danfoss VLT Series Design Manual

5. How to Install
5

Illustration 5.18: USB connection.

PC Software - MCT 10
All drives are equipped with a serial communication port. We provide a PC tool for communication
between PC and frequency converter, VLT Motion Control Tool MCT 10 Set-up Software.
MCT 10 Set-up Software
MCT 10 has been designed as an easy to use interactive tool for setting parameters in our fre-
quency converters.
The MCT 10 Set-up Software will be useful for:
•
•
•
•
•
•
MCT 10 Set-up Software support Profibus DP-V1 via a Master class 2 connection. It makes it
possible to on line read/write parameters in a frequency converter via the Profibus network. This
will eliminate the need for an extra communication network.
104
Planning a communication network off-line. MCT 10 contains a complete frequency con-
verter database
Commissioning frequency converters on line
Saving settings for all frequency converters
Replacing a drive in a network
Expanding an existing network
Future developed drives will be supported
MG.11.B2.02 - VLT
®
is a registered Danfoss trademark
®
VLT HVAC Drive Design Guide