Danfoss VLT Series Design Manual page 96

5. How to Install
1.
See section entitled
Armoured Control Cables
mination of control cables.
5
5.2.13. Switches S201, S202, and S801
Switches S201 (A53) and S202 (A54) are used
to select a current (0-20 mA) or a voltage (0
to 10 V) configuration of the analog input ter-
minals 53 and 54 respectively.
Switch S801 (BUS TER.) can be used to enable
termination on the RS-485 port (terminals 68
and 69).
See drawing
terminals
Default setting:
96
Use a clamp from the accessory bag
to connect the screen to the frequen-
cy converter decoupling plate for
control cables.
Earthing of Screened/
for the correct ter-
Diagram showing all electrical
Electrical Installation.
in section
S201 (A53) = OFF (voltage input)
S202 (A54) = OFF (voltage input)
S801 (Bus termination) = OFF
MG.11.B2.02 - VLT
®
is a registered Danfoss trademark
®
VLT HVAC Drive Design Guide