Trotec Laser Cut - Trotec Speedy Series Manual

Trotec Laser Cut

The cut data is transmitted from FineCut to Trotec JobControl and then laser cutting is performed by the Tro-
tec Speedy Laser Engravers (100/300/360/400).
This document covers the basic procedure for using FineCut 8 and RasterLink to print with a printer manufac-
tured by MIMAKI ENGINEERING CO., LTD. (hereinafter referred to as a "Mimaki printer") and carry out laser
cutting with the Trotec Speedy Laser Engraver. The following example shows the case when the FineCut and
Trotec software is installed on the LaserCut PC and the RasterLink software is installed on the RasterLink PC.
• Trotec Laser Cut procedure (when laser cutting is performed automatically according to out-
put from FineCut).
3. Transmission of cut data
1. Transmission of print data (P. 20)
Image quality
adjustment,
color adjustment,
etc.
2. Output of print data (P. 20)
*1. FineCut is compatible with Trotec Speedy Laser Engravers 100/300/360/400 laser engraving ma-
chines.
Data creation, etc.
Hot folder
Printing
Conversion
folder
Engraver (Printer Driver)
File conversion
Setting cutting conditions
Laser engraving machine control, etc.
Laser Cutting
100/300/360/400
- 3 -
Setting output
conditions
Auto
Auto
Auto
When UniDrive
Quick Print is ON
*1