Trotec Speedy Series Manual page 25

Laser cutting does not start under the set cutting
conditions.
Have the correct cutting conditions for the
material template been set with Trotec
JobControl?
Is the material template set by Trotec Job-
Control specified in the parameter file?
Has the parameter file set in Trotec UniD-
rive [UniDrive (Manual Mode)] been set as
the parameter file in Trotec UniDrive [Con-
version Folders Settings]?
Please contact our call center.
Yes
Yes
Yes
Please set the correct cutting conditions in
No
the material template in the Trotec JobCon-
trol [Material database] dialog.
( P.10 "Set the cutting conditions.")
Please set the correct material template in
No
the Trotec UniDrive [UniDrive (Manual
Mode)] dialog.
( P.31 "Checking/modifying the conver-
sion folder loading conditions")
Please set the correct parameter file.
No
( P.11 "Creating a cutting conditions
parameter file (Trotec UniDrive )",
"Associate the conversion folder with the cut-
ting conditions parameter file (Trotec UniD-
rive)")
- 25 -
P.13