Preparation - Trotec Speedy Series Manual

Preparation

Before starting laser cutting, it is necessary to install and configure each piece of software and prepare the
printer and Trotec Speedy Laser Engravers (100/300/360/400).
Please proceed to "Printing and cutting" (P.16) if this preparation has already been completed.
The following software applications are required for laser cutting.
Type
Mimaki
software
(Ver8.7 or later
Trotec
Trotec JobControl
software
Trotec
Trotec Engraver
driver
Trotec
Trotec UniDrive
software
*1.When using a version earlier than the specified version, download the installer for the upgraded version from the
Mimaki website (http://mimaki.com/).
• The following software/drivers are required in order to print with a Mimaki printer.
Type
Mimaki
software
Mimaki
Mimaki driver
driver
*1.This is required for printing with the Mimaki printer.
Software/
driver
This is the Adobe Illustrator plug-in cutting software.
The [Output to TrotecLaser] function only works with Adobe Illustrator
CC-CC2017 (Win/Mac). FineCut Trotec Speedy Laser Engravers func-
FineCut8
tions cannot be used in the case of versions prior to Adobe Illustrator
*1
)
CC.
For the installation procedure, please refer FineCut Reference Guide
"Chapter 1. Installation of FineCut".
Trotec JobControl is a software application that registers material tem-
plates, positions cut data, outputs cut data, etc. (Supplied with the Trotec
Speedy Laser Engravers: CD)
Please refer to the Trotec JobControl operation manual for the installa-
tion method.
This is the driver for the Trotec laser plotter that is installed along with
the JobControl software.
Trotec UniDrive is a software application that creates cutting conditions
parameter files and associates the conversion folder with cutting condi-
tions parameters, etc.
Please refer to the Trotec UniDrive Operation Manual for the installation
method.
Software/
driver
This software application is used to receive image data, edit data with
various functions, and send plot data to a Mimaki printer. (Supplied with
RasterLink
the Mimaki printer: CD)
Please refer to RasterLink installation guide bundled with the Mimaki
printer for the installation method.
This is the device driver to use the Mimaki inkjet printer / cutting plotter.
(Supplied with the Mimaki printer: CD)
*1
Please refer to Mimaki Driver Installation Guide bundled with the
Mimaki printer for the installation method.
Outline
Outline
- 7 -