Trotec Speedy Series Manual page 41

7. Output the print data to the RasterLink hot folder.
(1) Click the [Output to RasterLink] button on the
FineCut menu.
(2) Set it to print/cut on the [Layer] tab.
• Set Cut to ON for the alignment frame layer,
and set Print to ON for the print layer.
Print Cut
-
-
ON
(3) Select the RasterLink hot folder and click the
[Output] button.
• The print data is sent to the hot folder of Ras-
terLink.
8. Print using the Mimaki printer.
(1) Launch RasterLink.
• Print data is automatically loaded and then
added to the [Job List].
(2) Click the Mimaki printer tab.
(3) Select [RIP and Print] or [Immediate Print] on
the [Execution] panel and click the [Start] but-
ton.
• Printing starts.
(4) The Mimaki printer starts printing.
Layer
- Cut
ON Alignment frame
- Print
- 41 -