Trotec Vision Print&Cut - Trotec Speedy 300 flexx Operating Manual

TEMPERATURE SENSOR ALARM ACKNOWLEDGEMENT
Notice
The signal tone sounds again and again until the temperature returns to normal. Alternatively, switch off
the laser system and check the temperature sensors.
8.11.6 Trotec Vision Print&Cut
Information
The camera must be calibrated during installation and regularly aerwards. For more information, see the
online soware manual.
Press any key on the keypad to acknowledge the alarm.
The Vision option is a camera on the laser processing head
that reads the registration marks on the plate material, thus
detecting and compensating for distortions in the print.
The material is cut for an exact fit. Production times are
accelerated and cost-intensive miscuts are avoided.
In the control soware, under the settings tab, the camera
option must be checked to adapt the acceleration and travel to
the weight on the processing head.
Notice
When the camera is removed, the hook can be
removed to return the speed and travel distance
to maximum.
Operation
65