Laser Cutting Preparation Procedure - Trotec Speedy Series Manual

Laser cutting preparation procedure

Preparation (P.7)
1. Installing the Mimaki software/driver (P.8)
1. Install FineCut 8 on the LaserCut PC. (P.8)
2. Install RasterLink on the RasterLink PC. (P.8)
2. Configure FineCut (P.8)
1. Select the Trotec Speedy Laser Engraver in [Model]. (P.8)
2. Open the Trotec color swatch. (P.8)
3. Installing the Trotec software/driver (P.9)
1. Install Trotec Job Control on the LaserCut PC. (P.9)
2. Install Trotec UniDrive on the LaserCut PC. (P.9)
4. Configure the Trotec software (P.9)
1. Set the cutting conditions (Trotec JobControl) (P.10)
2. Create a cutting conditions parameter file
3. Associate the conversion folder
(Trotec UniDrive) (P. 13)
5. Prepare the Trotec Speedy Laser Engraver for laser cutting (P.15)
Please refer to the Trotec Speedy Laser Engraver operation manual.
6. Prepare the Mimaki printer for printing (P.15)
Please refer to the "Operation Manual" on the CD bundled with the Mimaki printer.
*1. Cutting conditions parameter file: A file that contains material templates and output conditions.
*2. Conversion folder: When a graphic file is placed in the conversion folder, it is automatically converted into a file for-
mat that is compatible with laser processing and then sent to Trotec JobControl. (When cut data
is output from FineCut to the conversion folder, it is automatically loaded into Trotec JobControl.)
*1.
(Trotec UniDrive) (P. 11)
*2
with the cutting conditions parameter file.
- 5 -