Table of Contents
Advertisement
CS101-Q370/C246/H310
► Internal I/O Ports
SATA (Serial ATA) Connectors
Features
•
2 Serial ATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0 and SATA 1)
•
Integrated Advanced Host Controller Interface (AHCI) controller
•
Supports RAID (for CS101-Q370/C246 only)
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Chipset menu ("PCH-IO Configuration" > "SATA And RST
Configuration") of the BIOS. Refer to the chapter 3 for more information.
Chapter 2 - Hardware Installation
GND
1
TX+
TX-
GND
SATA 1
RX-
RX+
SATA 0
7
GND
21
► Internal I/O Ports
SATA (Serial ATA) Power Connector
The SATA power connector supplies power to the SATA drive. Connect one end of the provided
power cable to the SATA power connector and the other end to your storage device.
www.dfi.com
4
SATA
5V
Power
GND
GND
+12V
1
Advertisement
Table of Contents
