Table of Contents
Advertisement
PIC-Q170/H110
► Internal I/O Connectors
Digital I/O Connector
The 8-bit Digital I/O connector provides powering-on function to external devices that are
connected to these connectors.
▼ Digital I/O Pin Assignment
Pin
Assignment
1
DIO_7
3
DIO_5
5
DIO_3
7
DIO_1
9
5V
Chapter 2 - Hardware Installation
1
9
Digital I/O Connector
10
2
Pin
Assignment
2
DIO_6
4
DIO_4
6
DIO_2
8
DIO_0
10
GND
► Internal I/O Connectors
SATA (Serial ATA) Connectors
The Serial ATA (SATA) connectors are used to connect the Serial ATA device. SATA 3.0 is sup-
ported by the five SATA ports and provides data rate up to 6Gb/s. Connect one end of the Se-
rial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu ("SATA Configuration" submenu) of the
BIOS. Refer to chapter 3 for more information.
▲ SATA 3.0 Pin Assignment
18
www.dfi.com
SATA 3/2/1/0 (from left to right)
1
GND
TX+
TX-
GND
RX-
RX+
GND
7
Advertisement
Table of Contents
