Table of Contents
Advertisement
CS101-Q370/C246/H310
► Internal I/O Ports
Chassis Intrusion Connector
Chassis
GND
Intrusion
2
Signal
1
The board supports the chassis intrusion detection function. Connect the chassis intrusion
sensor cable from the chassis to this connector. When the system's power is on and a chassis
intrusion occurred, an alarm will sound. When the system's power is off and a chassis intrusion
occurred, the alarm will sound only when the system restarts.
BIOS Setting
Configure the chassis intrusion detection function in the Advanced menu ("NCT6116D HW
Monitor" > "Case Open") of the BIOS. Refer to the chapter 3 for more information.
Chapter 2 - Hardware Installation
► Internal I/O Ports
Front Panel Connector
HDD-LED - Hard Disk Drive LED
Lighting of the LED indicates that the hard drive is being accessed.
RESET - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light up. When the system is in the S1 (POS
- Power On Suspend) state, it will blink at 1-second intervals. When the system is in the S3
(STR - Suspend To RAM) state, it will blink at 4-second intervals.
ATX-SW - ATX Power Switch
This switch is used to power on or off the system.
25
▼ Front Panel Pin Assignment
Pin Assignment
1
N.C.
3
HDD Power
PWR-LED
HD-LED
5
Signal
7
Ground
RESET
ATX-SW
9
Signal
11
N.C.
www.dfi.com
▼ Front Panel Connector
1
2
PWR-LED
HD-LED
RESET
ATX-SW
11 12
Pin Assignment
2
LED Power
4
LED Power
6
Signal
8
Ground
10
Signal
12
---
Advertisement
Table of Contents
