Table of Contents
Advertisement
CS101-Q370/C246/H310
► Advanced
The Advanced menu allows you to configure your system for basic operation. Some entries are
defaults required by the system board, while others, if enabled, will improve the performance
of your system or let you set some features according to your preference.
Important:
Setting incorrect field values may cause the system to malfunction.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Main
Advanced
Chipset
Security
RC ACPI Settings
CPU Configuration
Power & Performance
PCH-FW Configuration
Trusted Computing
PTN3460 Configuration
NCT6116D Super IO Configuration
NCT6116D HW Monitor
Serial Port Console Redirection
USB Configuration
CSM Configuration
USB Power Control
Network Stack Configuration
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Chapter 3 - BIOS Setup
Boot
Save & Exit
System ACPI Parameters.
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
RC ACPI Settings
Configure power management related settings in this page.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
RC ACPI Settings
Wake system from S5
State After G3
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Wake system from S5
When Enabled, the system will automatically power up at a designated time every day from
the Real-time clock (RTC) battery. More settings will be displayed once it's switched to [En-
abled] as detailed in the next page.
State After G3
Select between S0 State, Last State, and S5 State. This field is used to specify what state the
system is set to return to when power is re-applied after a power failure (G3 state).
32
www.dfi.com
Enable or disable Sys-
t e m w a k e o n a l a r m
[Disabled]
event. When enabled,
[S0 State]
System will wake on the
hr::min::sec specified
Select Screen
→←:
Select Item
↑↓:
Enter: Select
+/ - : Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save & Exit
ESC: Exit
Advertisement
Table of Contents
