Cleaning; Disinfection; Drying - Pari Vortex Instructions For Use

Short instruction
Be sure to clean VORTEX
The VORTEX must be cleaned thoroughly before the first use.
®
If contamination is visible VORTEX
The VORTEX can be cleaned as follows (see Figure 8-13)
®
8
9
10
11
12
13
Distributör: Active Care Sverup AB
Uggledalsvägen 47 · 427 40 Billdal
Tel: 031-917525 · Fax: 031-917505
E-post: info@activecare.se
hemsida: www.activecare.se
PARI GmbH
Spezialisten für effektive Inhalation
Moosstraße 3 · D-82319 Starnberg

Cleaning

®
must be cleaned immediately.
®
Remove the connecting ring and mask (if present).
Do not remove the mouthpiece and the protective cap.
Thoroughly clean all parts thoroughly in warm tap water and
dishwashing liquid.
Rinse all parts thoroughly under clean running water and then
shake to remove excess water.

Disinfection

Recommended method
With vaporisator or disinfector.
Alternatively, in boiling water
Place the individual parts of the VORTEX
(e.g. mask) in boiling water for at least 5 minutes.
Use a clean pot and fresh drinking water and ensure that there
is sufficient water in the pot.

Drying

The VORTEX and the accessories must be dried completely.
®
Due to its antistatic properties it can also be dried with a
clean tea towel.
and the accessories
®