Fronius Agilo 360.0-3 TL Operating Instructions Manual page 82

Protection devices
DC insulation measurement
Manifestation of DC overload
DC disconnector
Explanation of 1)
footnotes
2)
3)
4)
5)
6)
7)
Applicable stand-
-
ards and guide-
-
lines
-
CE mark
The devices comply with all the requisite and relevant standards and guidelines that form
part of the relevant EU Directive, and are therefore permitted to display the CE mark.
Grid interface
-
-
-
Parallel operation of generators
The inverter conforms to the
-
-
Circuit to prevent stand alone operation
The inverter has a circuit, approved by VDE in accordance with VDE-AR-N 4105, to pre-
vent stand alone operation.
Grid failure
The standard measurement and safety procedures integrated into the inverter ensure that
in the event of a grid failure, the feed-in of energy is immediately interrupted (e.g. switch-
off by the energy supplier or damage to lines).
80
The values quoted are default values; the inverter is configured specifically to meet
the needs of the country in question.
Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive)
PCC = interface to the public grid
Maximum current from the inverter to the solar module when an error occurs in the
inverter or when the insulation between the AC and DC side is defective
Guaranteed by the electrical configuration of the inverter
Current peak when switching on the inverter
Depending on the country setup
IEC 62109-1:2010 -
EN 61000-3-3:2008 -
EN 62233:2008
ÖVE/ÖNORM E 8001-4-712
VDE 0126-1-1/A1
VDE-AR-N 4105
"Guidelines for connection and parallel operation of generators on the low-voltage
grid" published by the German Electricity Industry Association (VDEW)
"Technical guidelines for parallel operation of generators with distribution networks"
published by the Austrian Association of Electricity Companies
Warning/shutdown
IEC 62109-2:2011 -
EN 61000-6-2:2005 -
7)
at R < 40 kOhm
ISO
Operating point shift
power limitation
Integrated
EN 61000-3-2:2006
EN 61000-6-3:2007/A1:2011