Advertisement
Available languages
Available languages
General
Device concept
The inverter converts the direct current created in the solar modules into alternating cur-
rent. This alternating current is fed into the public grid synchronously with the grid voltage.
The inverter has been developed exclusively for use in grid-connected photovoltaic sys-
tems; it is impossible to generate energy independently of the public grid.
Thanks to its design and the way it works, the inverter is extremely safe both to install and
to operate.
The inverter automatically monitors the public grid. In the event of abnormal grid condi-
tions, the inverter ceases operating immediately and stops feeding power into the grid (e.g.
if the grid is switched off, if there is an interruption, etc.).
Grid monitoring involves monitoring voltage, frequency and the stand-alone situation.
The inverter operates fully automatically. As soon after sunrise as there is sufficient energy
available from the solar modules, the inverter starts monitoring the grid. When insolation
has reached a sufficient level, the inverter starts feeding energy into the grid.
The inverter operates in such a way that the maximum possible amount of power is ob-
tained from the solar modules.
As soon as the power available has fallen below the level at which energy can be fed into
the grid, the inverter disconnects the power electronics completely from the grid and stops
running. It retains all its settings and stored data.
If the inverter becomes too hot, it automatically reduces the current output power in order
to protect itself.
Reasons for the inverter becoming too hot include the ambient temperature being too high
or inadequate heat dissipation.
50
(1)
(2)
(3)
(4)
(5)
Device design:
(9)
(1)
Swing door
(2)
Controls and indicators
(3)
Main switch
(4)
Lower cover
(5)
DC connection area
(8)
AC connection area on the rear
(7)
(6)
Fitting base
(7)
Rear cover
(6)
Fronius Agilo TL Outdoor only:
(8)
Outlet air unit
(9)
Inlet air attachment
Advertisement
