Default Settings; Pci-Mxi-2; Table 1-1. Pci-Mxi-2 Hardware Default Settings - National Instruments MXI VXI-PCI8026 Getting Started

Default Settings

PCI-MXI-2

© National Instruments Corporation
This should return a value, such as:
Return Status (0): SUCCESS.
value = 0x4ff6
If the value ends with
Instruments manufacturer ID from the ID register for the
VXI/VME-MXI-2.
You may now want to read the configuration registers from other VXI
devices in your system using the command
accesses only the upper 16 KB of A16 space. Try reading the registers from
one of the devices listed in the Resource Manager Display of
In this way, you can verify that your PCI-MXI-2 can access each of the
devices in your VXI system successfully.
You can also access VXI and VME devices that are configured in A16,
A24, and A32 address space by using the
For more information regarding
to the online help.
This section summarizes the hardware and software default settings for the
VXI/VME-PCI8026 kit. If you need more information about a particular
setting, or if you want to try a different configuration, please refer to the
appropriate hardware or software chapters in this manual. The manual
flowchart at the beginning of this chapter directs you to where to find the
information you need.
This section summarizes the hardware and software default settings for the
PCI-MXI-2.

Table 1-1. PCI-MXI-2 Hardware Default Settings

Hardware Component
U17 Switch 1 (FOV)
U17 Switch 2 (TST)
U17 Switch 3 (POS)
Chapter 1
, you have successfully read the National
ff6
vxiinreg
vxiin
operation and commands, refer
victext
OFF: PCI-MXI-2 boots off the
user-configured half of the EEPROM.
OFF: Factory configuration of the
EEPROM is protected.
OFF: Do not alter this setting.
1-9
Introduction and Quick Start
. This command
vxitedit
or commands.
vxiout
Default Setting
VXI/VME-PCI8026 for Linux
.