Table 2-1. Hardware Default Settings - National Instruments PC/104-GPIB Getting Started

Hardware Configuration
and Installation
Using the Hardware Default Settings
© National Instruments Corporation
This chapter contains instructions to help you configure and install your
PC/104-GPIB.
The PC/104-GPIB default settings are suitable for most PC/104 systems.
However, if the default settings conflict with another device in your
system, if you are installing the PC/104-GPIB in an 8-bit stack, or if you
need to install more than one PC/104-GPIB, you must reconfigure the
hardware.
Table 2-1 shows the default settings for the switches and jumpers on the
PC/104-GPIB.
PC/104-GPIB Setting
Base I/O Address (hex)
DMA Channel
Interrupt Line (IRQ)
To modify the default settings of the PC/104-GPIB, skip to the Configure
the Hardware (Optional) section of this chapter. If you do not need to
reconfigure the module, continue to the next section, Install the
Hardware.

Table 2-1. Hardware Default Settings

2-1
Chapter
2
Default
2C0
5
11
PC/104-GPIB for Windows NT