Table of Contents
Advertisement
© National Instruments Corporation
6.
Run
to re-adjust the PCI-MXI-2 configuration. Refer to
vxitedit
Chapter 6,
NI-VXI Configuration
utility.
7.
After saving the configuration, reboot the computer.
8.
Remove the top cover or access port to the PCI bus.
9.
Change switch 1 (FOV) on U17 to the OFF position.
10. Replace the computer cover.
11. Turn on the computer. If the computer does not boot with this
configuration, you will have to repeat these steps, modifying your
configuration until a final configuration is reached.
Appendix C
Utility, for instructions on using this
C-3
EEPROM Configuration
VXI/VME-PCI8026 for Linux
Advertisement
Table of Contents
